HC25FQ128GS

Features
● Serial Peripheral Interface
- Standard SPI: SCLK, /CS, SI, SO, /WP, /HOLD
- Dual SPI: SCLK, /CS, IO0, IO1, /WP, /HOLD
- Quad SPI: SCLK, /CS, IO0, IO1, IO2, IO3
- QPI: SCLK, /CS, IO0, IO1, IO2, IO3
- DTR (Double Transfer Rate) Read
● Read
- Normal Read (Serial): 80MHz clock rate
- Fast Read (Serial): 166MHz clock rate with 30PF load
- Dual I/O data transfer up to 266Mbits/S
- Quad I/O data transfer up to 532Mbits/S
- QPI data transfer up to 532Mbits/S
- DTR Quad I/O Data transfer up to 832Mbits/s
- Allows XIP (execute in place) Operation: Continuous Read with 8/16/32/64-byte Wrap
● Program
- Serial-input Page Program up to 256bytes
- Program Suspend and Resume
● Erase
- Block Erase (64/32 KB)
- Sector Erase (4 KB)
- Chip Erase
- Erase Suspend and Resume
● Program/Erase Speed
- Page Program time: 0.3ms typical
- Sector Erase time: 25ms typical
- Block Erase time: 0.07/0.14s typical
- Chip Erase time: 40s typical
● Flexible Architecture
- Sector of 4K-byte
- Block of 32/64K-byte
● Low Power Consumption
- 25mA maximum active current
- 5uA maximum power down current
● Software/Hardware Write Protection
- 3x1024-Byte Security Registers with OTP Locks
- Discoverable Parameters (SFDP) register
- Enable/Disable protection with WP Pin
- Write protect all/portion of memory via software - Top or Bottom, Sector or Block selection
● Single Supply Voltage
- Full voltage range: 2.7~3.6V
● Temperature Range
- Industrial (-40℃ to +85℃)
● Cycling Endurance/Data Retention
- Typical 100k Program-Erase cycles on any sector - Typical 20-year data retention